|
|
Post by DaveM on Jan 11, 2014 10:06:24 GMT
You only have to blink, and another new Quad appears. No GPS, just altitude hold, but FPV based on a similar Transmitter and monitor that pitprops uses for KAP
 |
|
|
|
Post by dreamcatcherwolf on Jan 11, 2014 16:56:07 GMT
Not the tx that Hubsan use for their smaller fpv, then... ![X4 FPV]() I don't know what is going on, I post a link to the Hubsan tx image, it appears in the preview, but disappears when I post... I'll try this way: www.hubsan.com/products/FPV/H107D.htmand scroll down. |
|
|
|
Post by DaveM on Jan 11, 2014 17:57:06 GMT
No different version Roy  Is this it   |
|
|
|
Post by dreamcatcherwolf on Jan 12, 2014 16:14:40 GMT
No different version Roy Is this it Yes Dave, that's it: how did you do that  |
|
|
|
Post by DaveM on Jan 12, 2014 18:35:16 GMT
If you are using your iMac and Safari, it should be like this: Navigate to the image you wish to post, right click the mouse and choose copy image address 
Then click the insert image icon
A box should pop up like this below, (delete the http:// bit)
Then paste what you have copied previously, and then the click Insert Image icon(in this example I have used another image from Hubsan) 
It should then appear when you create a post or reply to one Voila
|
|
|
|
Post by dreamcatcherwolf on Jan 12, 2014 22:30:35 GMT
That's pretty much what I did, as far as I can remember, it appeared in the preview, but when I posted it, it was gone... Question Mark
Oh well, I'll try again sometime with something else. Thanks Dave.
|
|
